Nagios Support Forum

I am facing a few issues with NCPA.

I have the Config Wizard version 1.2 and I am using the 1.7.2 NCPA agent version.

For a host that I have setup, everything is alerting Critical when the values have not met the thresholds.

I am getting this result when running the "Test Check Command" for each service (I removed the IP and token in the below examples for security purposes)

Disk Usage
COMMAND: /usr/local/nagios/libexec/check_ncpa.py -H 0.0.0.0 -t 'token' -P 5693 -M 'disk/logical/C:\|/used_percent' -w 85 -c 95
OUTPUT: Unable to run check on non-child node. Revise your query.

Memory Usage
COMMAND: /usr/local/nagios/libexec/check_ncpa.py -H 0.0.0.0 -t 'token' -P 5693 -M memory/virtual/percent -w 85 -c 95
OUTPUT: CRITICAL: percent was 46% | 'percent_0'=46%;8;9;

CPU Usage
COMMAND: /usr/local/nagios/libexec/check_ncpa.py -H 0.0.0.0 -t 'token' -P 5693 -M cpu/percent -w 85 -c 95
OUTPUT: CRITICAL: percent was 9%,0% | 'percent_0'=9%;8;9; 'percent_1'=0%;8;9;

Swap Usage
COMMAND: /usr/local/nagios/libexec/check_ncpa.py -H 0.0.0.0 -t 'token' -P 5693 -M memory/swap/percent -w 85 -c 95
OUTPUT: CRITICAL: percent was 28% | 'percent_0'=28%;8;9;

These issues have been resolved in NCPA 1.7.2 agent on Windows 2008 R2.

These issues have been resolved in NCPA 1.7.2 agent on Windows 2008 R2.

Is the issue resolved?

Yes with the new agent however it looks like the same issue with the RHEL NCPA agent. I guess I need to update all of them.

Here's a link that you may find handy:

http://assets.nagios.com/downloads/ncpa/download.php

Good luck with the update! I am locking this post. Please, start a new thread in case you have more issues/questions. Thanks!