Page 1 of 1
Different output for BPI services
Posted: Thu Oct 23, 2014 6:48 am
by WillemDH
Hello,
I made a few BPI groups this week. Two of these groups has a different OK output, which is strange as they are configured almost identically (in fact hey were cloned). It says XML:OK Instead of just OK
See screenshot. Any idea what might be causing the different output?
Grtz
Willem
Re: Different output for BPI services
Posted: Thu Oct 23, 2014 10:41 am
by lmiltchev
How did you clone these groups? Can you describe in details? I will try to recreate the issue in house.
Re: Different output for BPI services
Posted: Thu Oct 23, 2014 11:58 am
by WillemDH
Not with the bulk host modification wizard, but with the copy icon in CCM. First on the dummy host, then on the service, and then changing the bpi group parameter and the host / name for the copied service.
Re: Different output for BPI services
Posted: Thu Oct 23, 2014 2:29 pm
by lmiltchev
I don't think this is something you did (while cloning the service). I was able to recreate it even on the services that were not cloned. I was clicking repeatedly on the "Test Check Command" in the CCM. Initially, I would get a "correct" output, but then every time afterwords, I would get the "XML: ..." output.
It is confirmed that this is a bug. It should be fixed in the next release of XI.
Re: Different output for BPI services
Posted: Fri Oct 24, 2014 1:22 am
by WillemDH
Cheerz Ludmill, you can close the thread.
