Nagios Support Forum

Posted: **Fri Nov 07, 2014 10:17 am**

please suggest a plugin that should be capable of monitoring QOS traffic on a Cisco Rotuer.

We should be able to get report like,

1. Inbound and outbound QOS traffic utilization in percentage.(Maximum,Minimum,Average).
2. Inbound and outbound QOS traffic utilization in MB(Maximum. Minimum, Average).
3. Inbound and outbound QOS traffic utilization in MB in an excel sheet(ASCII Format).

We are also Ok if any one can write a plugin for us for the above requirement. We are also ready to pay for this. If anyone intrested please mail me at [email protected] Withe Subject line "Nagios Cisco QOS Plugin"

Thanks & Regards
Subash Rajakumar

Posted: **Fri Nov 07, 2014 10:19 am**

Looks like there is one plugin here, but it has no ratings, and no comments:

http://exchange.nagios.org/index.php?op ... isco%20QOS

Have you checked to see if you can get this information via SNMP? My guess is you can, and that the plugin uses it. Might be easier to use check_snmp against the device.

Posted: **Tue Nov 18, 2014 10:59 am**

Hi Slansing,

Sorry for the delayed response. I got the below error.

Code: Select all

[root@NagiosMon libexec]# ./sgichk_cisco_qos.pl -H 172.21.41.12 -C NagI0sNetMon
ERROR: QDepth table : Requested table is empty or does not exist.
[root@NagiosMon libexec]# ./sgichk_cisco_qos.pl -H 172.21.44.3 -C NagI0sNetMon
ERROR: QDepth table : Requested table is empty or does not exist.

The device is a cisco 7200 router. Also i am sure that this plugin is not gonna work, since the OID's used are different.

Posted: **Tue Nov 18, 2014 6:10 pm**

GDC_Net wrote:Also i am sure that this plugin is not gonna work, since the OID's used are different.

Indeed. You may need to poke around the exchange for another plugin:
http://exchange.nagios.org/

Nagios Support Forum

Cisco QOS

Cisco QOS

Re: Cisco QOS

Re: Cisco QOS

Re: Cisco QOS