Nagios Support Forum

Posted: **Wed Jan 28, 2015 12:04 pm**

Hi,

We have Nagios XI 2014R2.3.

I'm running the Network Switch/Router Wizard via CCM. The switch that I'm attempting to setup fails because it is taking a while to retrieve the SNMP info it need during its scan of interfaces. I'm polling this device (located in London) from our XI server in Boston. It (the wizard) times out in 15 seconds. I can run snmpwalk from the XI server with no issues. Is there a way to increase the timeout on the XI server to allow it to complete its scan successfully? I just need a few ports but this device has many that aren't used.

Posted: **Wed Jan 28, 2015 2:46 pm**

You can edit /etc/php.ini
change

Code: Select all

max_execution_time = 30

to

Code: Select all

max_execution_time = 300

Then restart apache

Code: Select all

service httpd restart

Posted: **Thu Jan 29, 2015 1:08 pm**

Thanks Scott. Worked perfectly. Pleae close.

Nagios Support Forum

XI and Network Switch Router Wizard Time Out

XI and Network Switch Router Wizard Time Out

Re: XI and Network Switch Router Wizard Time Out

Re: XI and Network Switch Router Wizard Time Out