Nagios Support Forum

When i scan interfaces in a specific switch to add on nagios xi, the wizard list all ports, ok.
But looking the image that a sent i have some ports 10 Gigab in this same switch, when i scan interfaces he shows me 1 Gigab and 10 Gigab ports and he puts wrong warning and critical for ports 10 Gigab. Problaby the wizard is calculating wrong when Higher bandwidth 1 Gigab.

50% and 80% utilization seems like a decent threshold for defaults. What specifically are you saying should be changed, and to what value?

The default bandwitdth is Gbps when i change to Mbps he does not change auto the warning and critical values ? i would like to see every port in Mbps by default.

You can close the ticket, i was thinking if i change the Gigab to Mbps he going to change auto the values. I apreciated the help.

We'll go ahead and close the thread. Thanks.