Nagios Support Forum

Dear Team,

I had added some services recently to nagios , after that apply configuration is not happening its not showing what is the error is.Please assist .

Checked 0 service escalations.
Checking service dependencies...
Checked 0 service dependencies.
Checking host escalations...
Checked 0 host escalations.
Checking host dependencies...
Checked 0 host dependencies.
Checking commands...
Checked 167 commands.
Checking time periods...
Checked 14 time periods.
Checking for circular paths between hosts...
Checking for circular host and service dependencies...
Checking global event handlers...
Checking obsessive compulsive processor commands...
Checking misc settings...

Total Warnings: 202
Total Errors: 1

***> One or more problems was encountered while running the pre-flight check...

Check your configuration file(s) to ensure that they contain valid
directives and data defintions. If you are upgrading from a previous
version of Nagios, you should be aware that some variables/definitions
may have been removed or modified in this version. Make sure to read
the HTML documentation regarding the config files, as well as the
'Whats New' section to find out what has changed.

What XI version are you on?

Go to Configure -> Core Config Manager, then on the left under Tools click Write Config Files. Then click Delete, then Write, then Verify and post a screenshot.

Dear Team,

We are using NagiosXI 2012R2.2

And in core configure manger >> tools >>write config files there is no delete option.

Your XI version is quite old. There have been a lot of improvements in both XI in general, and the CCM specifically. The current latest release is 2014R2.7 and I would strongly urge you to update before we continue troubleshooting.