Nagios Support Forum

Hi;

I am running the following command ( usually via automation):

./nagiosql_delete_service.php --id=35975

It comes back as successful
but it doesn't appear to actually remove it
That nagios server is at version Nagios XI 2014R2.0 and there are 15215 service checks defined so I don't know if size is an issue or if its something else, I could have sworn I tested it previously and it was working.
Thanks,
Paul

There were some bugs with the ql scripts and the CCM in your version and these files may have been effected. Is it possible to upgrade to 2014r2.7 to see if that resolves your issues?

Thanks

Ok you can just close this then and I can re-open a ticket when I complete the upgrade if the issue still exists.

Just a question on the upgrade , will it roll back my version of check_wmi_plus? it has in the past(I'm at version 1.581 and am using the pro license). If I'm not careful with it, based on ntlm our settings, it ends up locking out a number of our monitoring accounts.

I believe the your version of check_wmi_plus will be overwrittent by the upgrade. I would backup the check_wmi_plus.conf, check_wmi_plus.ini, and check_wmi_plus.pl prior to upgrading. Good luck with the upgrade!

I will be locking this topic. If you have any more issues/questions, please start a new thread.