Nagios Support Forum

I downloaded and installed the Nagios upgrade earlier today according to the "Nagios XI – How to Manually Update Nagios XI" earlier the upgrade seemed to finish correctly, nagios and httpd services are running and the logs (that I have found) look pretty clean. However when I go to
"https://<servername>/nagiosxi"

I get a login page however when I auth with either a good or bad password I get sent to a blank page with the following URL.

https://<servername>/nagiosxi/login.php

RHEL 5.11

Where do I start to troubleshoot this issue?

Can you post the install log that ran with the upgrade?

Should be in the directory where the nagiosxi tarball was unpacked.

Here is the Log

Do you remember the upgrade giving you a complete message like this after the upgrade finished:

===================
UPGRADE COMPLETED!
===================

I ask because it looks like either the install log became too long and didn't record the rest of the upgrade or the upgrade didn't complete.

make[1]: Leaving directory `/tmp/nagiosxi/subcomponents/extraplugins/check_mysql_health-2.1.8.2'
Extra Plugins upgraded OK
is the last entry in the log, I will snap back the config to a known good working point in time and re-attempt the upgrade

I snapped the machine back to pre-upgrade and attempted the upgrade again and the upgrade has failed again. I have attached the new log.

Does it just hang at the command line at the end?

It looks like it's related to yum, please try running yum install manually and see if it's hanging.

needed to add /sbin to path with the following command
export PATH="$PATH:/sbin"

Install seems to be running fine now.

Great, glad you got it working. Locking