Page 1 of 1
Nagios XI SNMP select specific host to monitor
Posted: Wed Feb 03, 2016 9:27 am
by rkobliski
Can you select which host you want to forward snmp results or is it all inclusive??? I only need this for 4 windows servers
Re: Nagios XI SNMP select specific host to monitor
Posted: Wed Feb 03, 2016 12:08 pm
by bwallace
Using the Windows SNMP Wizard, you can specify any host you want so they are all independent of one another. In the XI UI go to Configure > Configuration Wizards.. Windows SNMP - Is this what you're looking for?
Re: Nagios XI SNMP select specific host to monitor
Posted: Wed Feb 03, 2016 2:12 pm
by rkobliski
that may be it but requires installation of "NagiosXI-SNMPTrap-setup.sh" will get a copy and proceed and see if this solves my problem, had previously installed "snmptrap-bins.tar.bz2" but it looked like all or nothing when viewed in config...
Thanks, will post if this is solution...
Re: Nagios XI SNMP select specific host to monitor
Posted: Wed Feb 03, 2016 3:45 pm
by rkennedy
Sounds good - let us know how it goes and if you have any more questions.