Page 1 of 1
Stalking options with SNMP trap monitoring
Posted: Mon Oct 17, 2016 10:17 pm
by masterson
We are running XI 2014R1.3. We have enabled SNMP trap monitoring on it. We want to log all status change from the SNMP traps. We have enable all stalking option (C,W,O,U). We found that every non-ok status changes can be logged, but it doesn't log all status changes for OK status. Only the first OK status change can be logged. Is it the normal behavior for the stalking option on OK status?
Re: Stalking options with SNMP trap monitoring
Posted: Tue Oct 18, 2016 2:07 pm
by tgriep
You should see those state changes in the Event Log, do you see them there?
If you are running the State History report, it will only show you state changes and since the state stays the same, you will only see the first one.
Re: Stalking options with SNMP trap monitoring
Posted: Wed Oct 19, 2016 9:41 pm
by masterson
Yes, we found it in the event logs. Thanks a lot.
Re: Stalking options with SNMP trap monitoring
Posted: Thu Oct 20, 2016 8:52 am
by tgriep
If you don't have anymore questions, shall I close the post for you?
Re: Stalking options with SNMP trap monitoring
Posted: Tue Oct 25, 2016 4:38 am
by masterson
Yes, please