Page 1 of 2
Nagios DB parameter monitoring
Posted: Mon Nov 07, 2016 2:28 am
by pooja_nama
Hi all,
I have insatalled nagios, check_oracle_health plugin for DB parameter monitoring. When I am trying to tnsping to the DB client, I am able to connect but on nagios console it is showing: not able to connect to XX.XX.XX.XX:XXXX/SID, no sqplus.
Re: Nagios DB parameter monitoring
Posted: Mon Nov 07, 2016 3:35 pm
by mcapra
Did you follow our documentation for installing the plugin?
https://assets.nagios.com/downloads/nag ... ios-XI.pdf
Can you share the output of:
cpan look DBD::Oracle
Re: Nagios DB parameter monitoring
Posted: Tue Nov 08, 2016 3:40 am
by pooja_nama
PFA the output
Re: Nagios DB parameter monitoring
Posted: Tue Nov 08, 2016 11:30 am
by rkennedy
Please answer the above question, and review the document. The attached file does not appear to be the output for
cpan look DBD::Oracle. Please post it once again.
Re: Nagios DB parameter monitoring
Posted: Wed Nov 09, 2016 2:07 am
by pooja_nama
PFA the output.
Re: Nagios DB parameter monitoring
Posted: Wed Nov 09, 2016 3:25 am
by pooja_nama
PFA the updated output
Re: Nagios DB parameter monitoring
Posted: Wed Nov 09, 2016 10:30 am
by avandemore
Please show the full command and resulting output.
XI > Configure > CCM > Commands
Please attach a screenshot of the command you are trying to use.
Re: Nagios DB parameter monitoring
Posted: Wed Nov 09, 2016 11:59 pm
by pooja_nama
PFA the screenshot.
Re: Nagios DB parameter monitoring
Posted: Thu Nov 10, 2016 11:56 am
by avandemore
What I am looking for is whatever command you're trying to use which utilizes
tnsping similar to this:
service_managment.png
Also please post the output from the
Run Check Command
Re: Nagios DB parameter monitoring
Posted: Fri Nov 11, 2016 1:03 am
by pooja_nama
What is run check command. Linux dosent have any command like this.