NagiosNA
Posted: Wed May 17, 2017 3:34 pm
I'm attempting to deploy NagiosNA using the provided CentOS Hyper-V machine.
However when I boot up nagios I see that it fails to bind eth0
This is a HyperV switch with access to my network.
Because of this failure there is no IP associated with nagios and I can not continue the deployment.
Any suggestions?
EDIT: I figured it out I needed to add "Legacy Network Adapter" for the VM no Hyper-V drivers in CentOS.
However when I boot up nagios I see that it fails to bind eth0
This is a HyperV switch with access to my network.
Because of this failure there is no IP associated with nagios and I can not continue the deployment.
Any suggestions?
EDIT: I figured it out I needed to add "Legacy Network Adapter" for the VM no Hyper-V drivers in CentOS.