Nagios Support Forum

Would be beneficial to have a NCPA repo for the .DEB just as you do for .RPM

I filed an internal feature request, but it is not guaranteed when/if this is going to be implemented. Thanks!

A Repo is relatively simple to setup, can we put some priority on this?

Thank you.

This is actually in the early planning stages already. For reasons other than NCPA, actually.

We'll add NCPA, focus on that for the starting point, and bump priority a bit.

Just an update:

The repo is complete. All that's left is getting the certs up and moving the debs over. All that's left is the certificates, the packages, and then the documentation. I can't imagine it'll be much longer before it's up completely - but I'll try and remember to get you access as soon as the certs and packages are up.

bheden wrote:Just an update:

The repo is complete. All that's left is getting the certs up and moving the debs over. All that's left is the certificates, the packages, and then the documentation. I can't imagine it'll be much longer before it's up completely - but I'll try and remember to get you access as soon as the certs and packages are up.

Thank you. We'll check the site from time-to-time for an update on download information.

It sounds like this issue has been resolved. Is it okay if we lock this thread? Thanks for choosing the Nagios forums!

dwhitfield wrote:It sounds like this issue has been resolved. Is it okay if we lock this thread? Thanks for choosing the Nagios forums!

No. The changes have not been published at https://www.nagios.org/ncpa/

Ok. We'll leave it open. I was not given any sort of date when I asked about your thread this morning before posting. If I had to guess, I would guess it would be after the Fusion 4.0.1 release, which should be out by the end of the month.

Can you please provide a status update on this?