Nagios Support Forum

Hello

I'm on Nagios XI, i used the Vmware .ova to get the install done

I am using the command below to get the actual bandwidth that go through the interfaces of a router

/usr/local/nagios/libexec/check_snmp_int.pl -H x.x.x.x -C community -2 -n eth -f -k -w 1000,1000 -c 1200,1200
eth0:UP (552.9KBps/CRIT 2507.9KBps), eth1:UP (CRIT 2466.9KBps/CRIT 8087.0KBps), eth2:UP (93.0KBps/619.8KBps):(3 UP): CRITICAL | 'eth0_in_octet'=3151058755c 'eth0_out_octet'=2254878312c 'eth1_in_octet'=626765302c 'eth1_out_octet'=634153554c 'eth2_in_octet'=1137408010c 'eth2_out_octet'=160432245c

the command is working.

But the perfdata make the graph annoying to read : "eth2_out_octet'=160432245c" , etc ...

so i would like to have those values in mb/s

i tried to use the -B -M -Y to tweak those values.

I could have the results in bytes or in bits but i could never have them in mb/s

do someone experienced this before and have a solution ?

Thanks

Hello Norshok,

You're correct. The check command only gives you the option of returning values in bits or bytes. If you know perl, you could do math in the script itself, ie: B / 1024 / 1024

Alright, It worked

$perf_out .= sprintf("%.0f",($checkperf_out_raw[0] * 8)/1024/1024) .";";
$perf_out .= ($o_warn[0]!=0) ? $o_warn[0]*$warn_factor . ";" : ";";
$perf_out .= ($o_crit[0]!=0) ? $o_crit[0]*$warn_factor . ";" : ";";
$perf_out .= "0;". $$resultf{$oid_speed[$i]} ." ";
$perf_out .= "'" . $descr[$i] ."_out_Mbps'=";
$perf_out .= sprintf("%.0f",($checkperf_out_raw[1] * 8)/1024/1024) .";";
$perf_out .= ($o_warn[1]!=0) ? $o_warn[1]*$warn_factor . ";" : ";";
$perf_out .= ($o_crit[1]!=0) ? $o_crit[1]*$warn_factor . ";" : ";";
$perf_out .= "0;". $$resultf{$oid_speed[$i]} ." ";

Thank you

May we close this topic?

Yes, thanks again for the help

Closing topic as resolved.

Thank you for using the Nagios Support Forum.