Page 1 of 1
Esensors Websensor EM01B Celsius?
Posted: Wed May 30, 2018 4:26 am
by ottow
Hi,
Is there any way to get the EM01B to do Celsius rather than Fahrenheit?
Would work much better outside the US...
Thanks,
Otto
Re: Esensors Websensor EM01B Celsius?
Posted: Wed May 30, 2018 7:42 am
by scottwilkerson
The sensor reports what it is programed to.
If you bought a unit that report is Celsius it will report in Celsius.
This isn't based on Nagios it is based on the sensor, Nagios is just reporting the data the sensor gives.
Re: Esensors Websensor EM01B Celsius?
Posted: Wed May 30, 2018 9:06 am
by ottow
As your document at
https://assets.nagios.com/downloads/nag ... ios-XI.pdf specifically states "Temperature must be specified in Fahrenheit" is seemed reasonable to think there was a way to do this in C too. After all, it is just a conversion...
Re: Esensors Websensor EM01B Celsius?
Posted: Wed May 30, 2018 9:26 am
by tcanthonyii
Email the folks at esensors. There are new modules available on their github site that were not available or linked to anyway but from an email from them. They are extremely helpful. I worked with them for months working through some bad chips and bad code before it all got resolved. Regardless the new modules work great.
Re: Esensors Websensor EM01B Celsius?
Posted: Wed May 30, 2018 10:50 am
by scottwilkerson
tcanthonyii wrote:Email the folks at esensors. There are new modules available on their github site that were not available or linked to anyway but from an email from them. They are extremely helpful. I worked with them for months working through some bad chips and bad code before it all got resolved. Regardless the new modules work great.
Glad to hear it is resolved!