Nagios Support Forum

Hello,

V 5.5.0, 64-bit, VM, CentOS7

Applying a configuration does not end. The dots just keep going.

The last good snapshot was 14:52:57

The next bad snapshot was 15:05:25

I looked at my audit log, and saw the only changes were to 6 Contact Groups, which I activated.

Strangely, the audit log identifies the Contact Groups as Host Groups.

I deactivated them, and the apply still fails. Profile attached.

The contactgroups thought they had a relationship to a few services, but the services did not show the contact groups.

I deactivated the services, and the apply configuration worked.

I get the feeling there may be database damage.

But its working now.

Hello, @Bitflogger. What happens if you unassign and then reassign contact groups to the deactivated services? Looking at the DB log it looks like you ran out of space at some point and that could've caused database corruption.

There might be some permission errors in your configuration. Please run the following script:

Hello,

Looks like the contact groups names were duplicates.

Never mind!

Earl

Is it safe to lock this topic then?

Yes, please do.