Page 1 of 1
Apply Config doesn't do anything
Posted: Mon Aug 27, 2018 2:16 pm
by mkeey
Sat here looking at the little dots crawl across my screen for about 15 minutes after I clicked on "Apply Configuration". Nothing happened. Exited page by clicking on CCM to check definitions.
Cleared Config Files and tried again.................................... Got tired of waiting and exited page again to open this case.
Re: Apply Config doesn't do anything
Posted: Mon Aug 27, 2018 3:09 pm
by scottwilkerson
Can you follow the steps in this document and see if it resolves the issue
https://support.nagios.com/kb/article.php?id=34
If not, run the apply configuration then send the results of the following command
Code: Select all
tail -50 /usr/local/nagiosxi/var/cmdsubsys.log
Re: Apply Config doesn't do anything
Posted: Thu Aug 30, 2018 8:16 am
by mkeey
From my Linux Admin...
I went through the vendors code line by line and it appears there was a lock file that was preventing the restart so I removed the lock file.
Re: Apply Config doesn't do anything
Posted: Thu Aug 30, 2018 8:40 am
by scottwilkerson
Is apply config working form the UI as expected now?
Re: Apply Config doesn't do anything
Posted: Tue Sep 04, 2018 8:39 am
by mkeey
Yes
Re: Apply Config doesn't do anything
Posted: Tue Sep 04, 2018 10:10 am
by scottwilkerson
mkeey wrote:Yes
Great, Locking thread