Nagios Support Forum

Posted: **Mon Oct 08, 2018 1:55 pm**

Hello,

I have installed the NRPE plugin on a couple remote hosts using the following guide:
https://assets.nagios.com/downloads/nag ... _Agent.pdf

After following those steps and adding the standard checks in NagiosXI>Configuration Wizard, all of my checks (except ping) give the same error:
"CHECK_NRPE: Error - Could not connect to 192.168.1.xxx: Connection reset by peer"

I have tried everything in the following article but this did not resolve the issue:
https://support.nagios.com/kb/article/n ... e-615.html

I have followed the XINETD steps as we appear to be utilizing this service.

Does anyone have any suggestions? Is xinetd needed, or is there a way to use nrpe without xinetd?

Thanks so much for the help.

Posted: **Mon Oct 08, 2018 4:02 pm**

Could you please double check that the IP address for only_from is specified correctly in the '/etc/xinetd.d/nrpe'?
It should look similar to:

Code: Select all

service nrpe
{
    disable = no
    per_source = 25
    ...
    only_from= 127.0.0.1 192.168.xxx.xxx
}

where the IP address is the XI server address. I would like to emphasize that the value for only_from is a space-delimited list, not comma.
Also it is easy to forget to restart the xinetd service. The changed configuration will not take effect unless it is restarted.

Code: Select all

service xinetd restart

It's also possible that nrpe traffic from the XI is being blocked by a firewall if you have one enabled. NRPE by default uses port 5666.
For example, in the case of iptables, you can add a rule to accept the nrpe traffic from the XI like below.

Code: Select all

iptables -A INPUT -p tcp -s 192.168.xxx.xxx --dport 5666 -j ACCEPT

Posted: **Mon Oct 08, 2018 4:04 pm**

We used Icinga to monitor in the past. Is any additional configuration needed after utilizing Icinga in the past? It seems a lot of configs/files are similar which might be causing conflicts?

Posted: **Tue Oct 09, 2018 6:50 am**

opensource300 wrote:We used Icinga to monitor in the past. Is any additional configuration needed after utilizing Icinga in the past? It seems a lot of configs/files are similar which might be causing conflicts?

It is possible, while some of those configs may be similar, that is a different project not supported by us and may have configs that are incompatible.

Nagios Support Forum

Issues after installing NRPE - Connection reset by peer

Issues after installing NRPE - Connection reset by peer

Re: Issues after installing NRPE - Connection reset by peer

Re: Issues after installing NRPE - Connection reset by peer

Re: Issues after installing NRPE - Connection reset by peer