Alarm output state is different from service state
Posted: Thu Oct 18, 2018 7:55 am
Hi,
We have a situation where under "All Service Problems", a particular service is listed with unknown state.
When checking the service from CCM, and executing the "Run check command", the output is listed as OK. { state OK for Nagios } .
When checking from the alarm page, and executing the "Force an immediate check", we get that process has been submitted, page is refreshed, however we end up with blank page.
I confirmed that service is under the correct host.
What else can be checked from our side?
We have a situation where under "All Service Problems", a particular service is listed with unknown state.
When checking the service from CCM, and executing the "Run check command", the output is listed as OK. { state OK for Nagios } .
When checking from the alarm page, and executing the "Force an immediate check", we get that process has been submitted, page is refreshed, however we end up with blank page.
I confirmed that service is under the correct host.
What else can be checked from our side?