Nagios Support Forum

Hi,

My customer is looking for using Nagios NNA and a tool called manage engine.

One of the major advantages according to him that the data on that tool is sampled every minute, wheres in NNA it looks to be every 5 minutes (from what I see in the graph it presents data in 5 min blocks at the lowest).

Is there any configuration or way to decrease this number to lets say 1 minute or potentially lower? I would love if this would have been "Real time" or even near real time.

Any suggestions will be appreciated.

Thanks
E

The sample rate for the graph is a 5 minute lookback however the data that comes into Network Analyzer and what can be viewed and queried is in real-time.

Thanks for the help Scott. Is there any chance to change the report data to 1 minute intervals?
If not - how would you go about querying the data? would that be an API call?

eladfe wrote:Is there any chance to change the report data to 1 minute intervals? If not - how would you go about querying the data? would that be an API call?

The graph cannot be changed to a 1 minute interval, however the Reports and Queries use realtime data.

If you run any report, or Query, it uses realtime data. This doesn't require any special API call.