Nagios Support Forum

I have check_drivesize running to a host that has 40 disk/mount points on it.

-c check_drivesize "perf-config=*(unit:g)" -a "warn=used>90%" "crit=used>95%" show-all "exclude=A:\\"

This check works fine but the resulting output seems to be cut off. Is there a way to display all of the output?

Is the output cut off if you run it from the CLI (from an SSH session)?

Please attach your nsclient.ini for review.

What version of nsclient++ are you running?

It could either be the nsclient side or the XI side.

First check from the XI CLI (SSH session) and see if it's cut off.
- If it IS cut off, then it's your agent or the check_nrpe version

If it's not cut off, follow this guide:

https://support.nagios.com/kb/article/n ... s-478.html