Nagios Support Forum

the only chatter I have seen on this subject is years old, so if you use the switch wizard you can see the ETH ports which is great but if you have point to points and using Siklue or Ceragon radios for example the radios them selves are capable of providing link status and speed info.

Any ideas how to actually get hold of this? I am aware could do it manually but am very surprised there is not standard or template for such radios links / health checks.

If you know the SNMP OID that reports that you can run the SNMP wizard and monitor those OIDs

without documentation is very difficult getting the documentation is the hard part, thanks for the tip though.

sharding wrote:without documentation is very difficult getting the documentation is the hard part, thanks for the tip though.

Ya, you would have to contact the manufacturer for the docs on what the OIDs would be...