Page 1 of 1
How to include performance data in the service detail
Posted: Thu Nov 07, 2019 6:43 pm
by awilson
Hi. We are running 5.4.4 on RHEL 6.
We have a service check using nrpe to trigger an NSClient++ check_cpu call. The Run Check Command output is
OK: CPU load is ok.|'total 5m'=7%;80;90 'total 1m'=6%;80;90 'total 5s'=4%;80;90
The Service Status row just shows
OK: CPU load is ok.
What did I miss?
Thanks!
Re: How to include performance data in the service detail
Posted: Fri Nov 08, 2019 10:09 am
by scottwilkerson
The performance data displays on the Advanced Tab in the Service Status Detail page
Re: How to include performance data in the service detail
Posted: Fri Nov 08, 2019 2:12 pm
by awilson
Thanks. I understand. It has to be to the left of the "|" to show. Like this.
OK: '/' is at 12% capacity, total 5.1GB, used 0.6GB (11.3%), free 4.5GB (88.7%) | 'used space'=1212632B;9673113;10210508;0;10747904 'used space (pct.)'=11.3%;90;95;0;100
Thanks.
While I have you, is there a way to get nsclient to include that type of information on both sides?
Thanks!
Re: How to include performance data in the service detail
Posted: Fri Nov 08, 2019 2:16 pm
by scottwilkerson
awilson wrote:
While I have you, is there a way to get nsclient to include that type of information on both sides?
Not that I know of.
Re: How to include performance data in the service detail
Posted: Mon Nov 11, 2019 1:27 pm
by awilson
Thank you. Please close this.
Re: How to include performance data in the service detail
Posted: Mon Nov 11, 2019 1:34 pm
by scottwilkerson
awilson wrote:Thank you. Please close this.
Great!
Locking