XI: 5.7.3 - did the ndo3 "slowness" fix make the release?
Posted: Fri Sep 04, 2020 2:56 pm
Ahoy folks,
Semi recently I attempted the upgrade from XI 5.6.x to 5.7.2 in my PROD ENV.
Naturally I performed the same upgrade in my TEST ENV and it went off fine.
However, the quantity of checks / scale of my PROD ENV is different than TEST.
To that end, I got bit by the ndo3 bug (reported also by a few others on these forums), where it acts very slowly, and fails to load the "Monitoring Engine Check Statistics" (and possibly other areas).
Via a support ticket, I understood there to be two main options:
1.) Stay at 5.7.x, but downgrade back to ndo2db (not a palatable state for our PROD ENV).
2.) Revert back to 5.6.x, and wait for XI 5.7.3 to be released (which was slated to have the ndo3 fix included).
Thus, I see XI 5.7.3 is released, but observe no mention of the ndo3 "fix" in the changelog (https://www.nagios.com/downloads/nagios-xi/change-log/).
Did the fix make it into this release, or is this still pending?
I would rather ask ahead of time, and save a lot of grief of checking to see mid-upgrade.
Thank you for your time,
Semi recently I attempted the upgrade from XI 5.6.x to 5.7.2 in my PROD ENV.
Naturally I performed the same upgrade in my TEST ENV and it went off fine.
However, the quantity of checks / scale of my PROD ENV is different than TEST.
To that end, I got bit by the ndo3 bug (reported also by a few others on these forums), where it acts very slowly, and fails to load the "Monitoring Engine Check Statistics" (and possibly other areas).
Via a support ticket, I understood there to be two main options:
1.) Stay at 5.7.x, but downgrade back to ndo2db (not a palatable state for our PROD ENV).
2.) Revert back to 5.6.x, and wait for XI 5.7.3 to be released (which was slated to have the ndo3 fix included).
Thus, I see XI 5.7.3 is released, but observe no mention of the ndo3 "fix" in the changelog (https://www.nagios.com/downloads/nagios-xi/change-log/).
Did the fix make it into this release, or is this still pending?
I would rather ask ahead of time, and save a lot of grief of checking to see mid-upgrade.
Thank you for your time,