Nagios Support Forum

Posted: **Mon Feb 08, 2021 9:23 am**

I spoke too fast on closing out my last issue. Modifying the ModGearman install script to account for the release name change in CentOS worked to move it past the first error. However, after a minute or two it errored out with the information below.

Error: Unable to install Packages

Error: Unable to find a match: gearmand

I've tried installing it on an older CentOS 7 box and ran into quite a few errors for things missing as well. Are there some prerequisites I am missing for the worker side install?

Posted: **Mon Feb 08, 2021 6:16 pm**

You'll need to do this on CentOS 8:

Code: Select all

yum install https://repo.nagios.com/nagios/8/nagios-repo-8-1.el8.noarch.rpm -y
yum config-manager --enable powertools
yum install epel-release -y

Then make sure this line in the ModGearmanInstall.sh:

Code: Select all

if rpm -q centos-release; then

Looks like this:

Code: Select all

if rpm -q centos-release || rpm -q centos-linux-release; then

Then run the ./ModGearmanInstall.sh --type=worker command.

And this on CentOS 7:

Code: Select all

yum install https://repo.nagios.com/nagios/7/nagios-repo-7-4.el7.noarch.rpm -y
yum install epel-release -y

Then run the ./ModGearmanInstall.sh --type=worker command.

Nagios Support Forum

Issues with ModGearman worker script

Issues with ModGearman worker script

Re: Issues with ModGearman worker script