Script help please
Posted: Wed Feb 10, 2021 8:53 am
Hi, I am running a powershell script which stops and starts a service, it is a very simple one that stops a service, waits a number of seconds then restarts the service and sends an email as below
Service enters critical state
Calls this command
$USER1$/check_ncpa.py -H $HOSTADDRESS$ -t 'mytoken' -P 5693 -M 'plugins/myscript.ps1' -q "args=-servicename myservice -waittorestart 5"
Which in turn calls myscript.ps1
stop-Service $servicename
start-sleep $waittorestart
start-Service $servicename
postie -host:my host -to:my to email address -from:my from email address -s:"My subject" -msg:"my message here"
My issue is when I call this script it seems to run and restart the service when the check enters critical and then runs again when it changes back to OK from critical
Can anyone assist me please
Thanks in advance
Service enters critical state
Calls this command
$USER1$/check_ncpa.py -H $HOSTADDRESS$ -t 'mytoken' -P 5693 -M 'plugins/myscript.ps1' -q "args=-servicename myservice -waittorestart 5"
Which in turn calls myscript.ps1
stop-Service $servicename
start-sleep $waittorestart
start-Service $servicename
postie -host:my host -to:my to email address -from:my from email address -s:"My subject" -msg:"my message here"
My issue is when I call this script it seems to run and restart the service when the check enters critical and then runs again when it changes back to OK from critical
Can anyone assist me please
Thanks in advance