Page 1 of 1
SNMP Traps Visible in NXTI but Not Alerting Out
Posted: Tue Apr 27, 2021 10:48 am
by mrochelle
I have been attempting to setup SNMP Traps from NLS and the snmp traps are coming in from NLS and showing up in NXTI. I have viewed the SNMP tutorials and documentation which clearly indicate how to address if not using NXTI. Attached is the snmptt.conf.nxti file. The traps come through as OK only.
snmptt_conf_nxti_archive.tar.gz
Re: SNMP Traps Visible in NXTI but Not Alerting Out
Posted: Tue Apr 27, 2021 6:53 pm
by ssax
You would need to edit the trap definition in Admin > SNMP Trap Interface > Defined Traps and change the Severity to Warning or Critical under the Passive Service Setup.
Re: SNMP Traps Visible in NXTI but Not Alerting Out
Posted: Tue Apr 27, 2021 8:36 pm
by mrochelle
Lock it up. Thank You
Re: SNMP Traps Visible in NXTI but Not Alerting Out
Posted: Wed Apr 28, 2021 6:29 am
by scottwilkerson
mrochelle wrote:Lock it up. Thank You
Locking thread