Page 1 of 1
Service Status and Host Status not Updating after 1.3 Upgrad
Posted: Fri Dec 07, 2012 1:51 pm
by isadmin
The web interface shows alerts on some of our interface checks but the command line returns without error? So the web interface is not updating with the service check results.
OK: host '10.x.x.x, interfaces up: 3, down: 0, dormant: 0, excluded: 0, unused: 0 |up=3,down=0,dormant=0,excluded=0,unused=0
Re: Service Status and Host Status not Updating after 1.3 Up
Posted: Fri Dec 07, 2012 2:29 pm
by slansing
Could you post an image of the service status list that is not updating? Are you getting any sort of error on the Web UI? Will the service status page load?
Re: Service Status and Host Status not Updating after 1.3 Up
Posted: Fri Dec 07, 2012 3:01 pm
by isadmin
[img]
snapshot9.png
[/img]
The service check that isnt updating is RecoverpOint Interface Check
Page does load .....I had an issue after the upgrade to 1.3 this morning with host and service status not loading but I did a DB repair and that was rolsolved.
This started after a reboot of the server.
Re: Service Status and Host Status not Updating after 1.3 Up
Posted: Mon Dec 10, 2012 10:04 am
by lmiltchev
...but I did a DB repair and that was rolsolved...
Is your issue resolved now or you still have problems?
Re: Service Status and Host Status not Updating after 1.3 Up
Posted: Mon Dec 17, 2012 9:15 am
by isadmin
It appears to be ok now.
Thanks