Home » Categories » Multiple Categories

Nagios XI - How to Monitor an AKCP SensorProbe2 using SNMP

How to Monitor an AKCP SensorProbe2 using SNMP

This document describes how to monitor an AKCP sensorProbe2 device with Nagios® XI™ in order to be alerted when temperature, humidity, or other environmental variables exceed specific thresholds.

This document outlines how to monitor the Dual Temperature/Humidity sensor connected to the sensorProbe2, however various AKCP intelligent sensors can be connected via the RJ45 connectors to the sensorProbe devices and then monitored in Nagios XI in a similar manor.

Documentation - How to Monitor an AKCP SensorProbe2 using SNMP


Final Thoughts

For any support related questions please visit the Nagios Support Forums at:


1 (2)
Article Rating (2 Votes)
Rate this article
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Monitoring Linux using NCPA
Viewed 4098 times since Fri, Dec 4, 2020
SNMP (Simple Network Management Protocol)
Viewed 34238 times since Mon, Feb 2, 2015
Nagios XI - Best Practices for Managing Configs
Viewed 6671 times since Wed, Jul 19, 2017
Nagios XI - Redundancy And Security Planning
Viewed 3406 times since Sun, Mar 25, 2018
Nagios XI - Adding Services To Pre-existing Switch or Router
Viewed 7198 times since Wed, Jan 27, 2016
Nagios XI - Monitoring VMware With Nagios XI
Viewed 8488 times since Thu, Jan 28, 2016
Nagios XI - How To Monitor Jetty JMX
Viewed 2596 times since Mon, Apr 29, 2019
Nagios XI - Problems with $ Signs in the Check Command
Viewed 6277 times since Tue, Jan 26, 2016
Nagios XI - Monitor Active Directory with LDAP
Viewed 6447 times since Thu, Jan 28, 2016
Nagios XI - Folder Watch Wizard
Viewed 6622 times since Tue, Mar 3, 2015