Page 10 of 10
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 2:15 pm
by skypete
where would this be located again is that service command right?
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 2:23 pm
by skypete
define service {
host_name Testserver1
service_description Print Spooler
check_command check_nrpe!check_process!process=spoolsv.exe!show-all
max_check_attempts 1
event_handler restart-service
check_interval 3
retry_interval 1
check_period 24x7
notification_interval 60
notification_period 24x7
contacts nagiosadmin
_SERVICE Spooler
}
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 2:49 pm
by scottwilkerson
no it's a command you defined with a name restart-service
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 3:23 pm
by skypete
This where i copied it too
################################################################################
# NOTE: The following 'check_...' commands are used to monitor services on
# both local and remote hosts.
################################################################################
# 'restart-service' command definition
define command {
command_name restart-service
command_line $USER1$/restart_service.sh $SERVICESTATE$ $HOSTADDRESS$ $_SERVICESERVICE$T$
}
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 3:45 pm
by npolovenko
@skypete, Looks like you haven't replaced the "restart-service" command definition(see my post on the page#6).
From:
Code: Select all
define command {
command_name restart-service
command_line $USER1$/restart_service.sh $SERVICESTATE$ $HOSTADDRESS$ $_SERVICESERVICE$T$
}
To:
Code: Select all
define command {
command_name restart-service
command_line $USER1$/restart_service.sh $SERVICESTATE$ $HOSTADDRESS$ $_SERVICESERVICE$
}
Please replace the command and then restart the nagios service with:
Let us know if the event handler starts working.
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 3:46 pm
by scottwilkerson
You have a typo there...
lets replace this
Code: Select all
command_line $USER1$/restart_service.sh $SERVICESTATE$ $HOSTADDRESS$ $_SERVICESERVICE$T$
with this
Code: Select all
command_line $USER1$/restart_service.sh $SERVICESTATE$ $HOSTADDRESS$ $_SERVICESERVICE$
then restart the nagios service
Then it should work
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 4:45 pm
by skypete
Im sorry still not working.
Re: Using NRPE for windows server
Posted: Fri Mar 02, 2018 5:16 pm
by scottwilkerson
skypete wrote:Im sorry still not working.
Please copy and paste the command out of your config again..
Please verify you restarted nagios.
Please describe how you tested that it is working (e.g. how long you waited until after you stopped the service)