starting nagios xi web infterface

[twingard51]

After using the system-config-tui utility to bring my new VM host online so it is pingable, I am unable to access the web page to complete the setup and initialization. Httpd running, mysql running , and nagios running. I believe I will be okay if I can get to the web page

[tmcdonald]

What OS and version is this on?

[twingard51]

uname -a = linux 2.6.32-504.81.e16.X86_64 #1SMP Wed Jan 28 21:11:36 UTC 2015 x86_64 x86 GNU/Linux

[tmcdonald]

That's the kernel version. Please run the following command and show us the output:

Code: Select all

cat /etc/*release*

[twingard51]

more on my problem with the web site...looking at the http.conf , shouldn't it be configured to listen to requests on a specific ipaddress, such as the one I assigned to the device. The ipaddress is reachable and I can reach other hosts. Also at some should I install VMtools and change to the VMadapter for the network device.

[twingard51]

sorry I missed your reply..I am running CentOS 6.6

[ssax]

The default listens on *:80 which listens on all IP addresses and is recommended unless you have multiple NICs and a reason to not listen on other interfaces.

As long as you have network connectivity you're fine, you're not required to install vmtools.

Please post the output of the following:

Code: Select all

sestatus

Code: Select all

iptables -L

[twingard51]

senstaus - disabled

iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
ACCEPT all anywhere anywhere state RELATED<ESTABLISHED

and so on for all tcp protocols (ssh,http,https, except icmp which is REJECT

[twingard51]

sorry sestatus -disabled

[jolson]

Could you temporarily disable your firewall to ensure that this isn't a firewall problem, or is that not an option?

Code: Select all

service iptables stop

Access the IP address. Example:

Code: Select all

http://192.168.1.1/nagiosxi
https://192.168.1.1/nagiosxi

Ensure that you can ping your host:

Code: Select all

ping 192.168.1.1

Turn iptables back on:

Code: Select all

service iptables start

Please let us know if that works for you. Thank you!