Nagios XI SNMP select specific host to monitor

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
rkobliski
Posts: 21
Joined: Fri Jan 27, 2012 4:04 pm
Location: Rincon, GA

Nagios XI SNMP select specific host to monitor

Post by rkobliski »

Can you select which host you want to forward snmp results or is it all inclusive??? I only need this for 4 windows servers
Top
bwallace
Posts: 1145
Joined: Tue Nov 17, 2015 1:57 pm

Re: Nagios XI SNMP select specific host to monitor

Post by bwallace »

Using the Windows SNMP Wizard, you can specify any host you want so they are all independent of one another. In the XI UI go to Configure > Configuration Wizards.. Windows SNMP - Is this what you're looking for?
Be sure to check out the Knowledgebase for helpful articles and solutions!
Top
rkobliski
Posts: 21
Joined: Fri Jan 27, 2012 4:04 pm
Location: Rincon, GA

Re: Nagios XI SNMP select specific host to monitor

Post by rkobliski »

that may be it but requires installation of "NagiosXI-SNMPTrap-setup.sh" will get a copy and proceed and see if this solves my problem, had previously installed "snmptrap-bins.tar.bz2" but it looked like all or nothing when viewed in config...
Thanks, will post if this is solution...
Top
rkennedy
Posts: 6579
Joined: Mon Oct 05, 2015 11:45 am

Re: Nagios XI SNMP select specific host to monitor

Post by rkennedy »

Sounds good - let us know how it goes and if you have any more questions.
Former Nagios Employee
Top
Locked

Return to “Nagios XI”