Good afternoon,
I was wondering if, when you restart Nagios Core, if you can set it to send an alert for all the alert states that are currently active (e.g. disk space at warning or critical level), rather than it waiting for an alert status to change and only then sending an email?
Thanks in advance
Pete
Notification_Interval query
Re: Notification_Interval query
If a state of a service is currently in warning / critical state, then you should have already received a notification about this depending on your settings.
Just to make sure I understand correctly, on a restart, you want notifications to be sent out once again for all services that are in any state that isn't OK? Is that correct?
Just to make sure I understand correctly, on a restart, you want notifications to be sent out once again for all services that are in any state that isn't OK? Is that correct?
Former Nagios Employee
-
neworderfac33
- Posts: 329
- Joined: Fri Jul 24, 2015 11:04 am
Re: Notification_Interval query
Yes, that's correct! 
Re: Notification_Interval query
It's not currently possible, the closest you could come would be to set retain_state_information=0 in your nagios.cfg OR set retain_status_information 0 on your hosts/services but it would still wait until the next check occurs.
-
neworderfac33
- Posts: 329
- Joined: Fri Jul 24, 2015 11:04 am
Re: Notification_Interval query
That's fine - at least I can present the answer when I'm asked the question!
You can close this thread now - thank you.
Pete
You can close this thread now - thank you.
Pete
Re: Notification_Interval query
Closing this per your request
Former Nagios employee
https://www.mcapra.com/
https://www.mcapra.com/