access layer switch monitoring

ctrusler · Post by **ctrusler** » Mon Jul 25, 2016 3:35 pm

Hi, I am new to Nagios (installed it today) and trying to get it up and running. I added in one of our Cisco 4507RE chassis today as a test. This is an access layer switch. I want know status of all ports if I look but I don't want alerts or errors of end user ports that are down. how do I configure that? I know in solarwinds (which we are moving from) they had an option for this.

Post by **Box293** » Mon Jul 25, 2016 4:36 pm

Use the "Network Switch / Router" configuration wizard, you can choose what ports you want to monitor.

ctrusler · Post by **ctrusler** » Mon Jul 25, 2016 4:38 pm

I want to monitor all the ports but not get alerts for or shown in an error status the end user ports that are down.

Post by **Box293** » Mon Jul 25, 2016 4:42 pm

You can select in the wizard to not have a port status check per port.

ctrusler · Post by **ctrusler** » Mon Jul 25, 2016 5:01 pm

how can I do that after everything is already in Nagios? like I said, we just installed it today

Post by **Box293** » Mon Jul 25, 2016 5:03 pm

Configure menu > Core Configuration Manager.
Monitoring > Services
Here you can delete the status services.
Then Apply Configuration.

Nagios Support Forum

access layer switch monitoring

access layer switch monitoring

Re: access layer switch monitoring

Re: access layer switch monitoring

Re: access layer switch monitoring

Re: access layer switch monitoring

Re: access layer switch monitoring