CHECK_NRPE: Error - Could not complete SSL handshake.

[ednaldojta]

good morning friends!
I set up a Linux host, with the support of NRPE agent. But me the message "CHECK_NRPE: Error - Could Not complete SSL handshake.

However, when I run nmap command, check that the port 5666 is open.

Follows as spoken.

[mcapra]

Usually this pertains to an "allowed hosts" issue in the NRPE or xinetd configuration files. The other common issue is that NRPE was not compiled with SSL.

Have you tried all the solutions mentioned in our "NRPE Troubleshooting" document? (refer to section III)
https://assets.nagios.com/downloads/nag ... utions.pdf