Hello,
Since the content of service status detail can't show full messages of service, we are difficult to perform a health check for these services.
How can we configure the content of service status detail, so that we can refine the limitation??
Thanks.
Content of Service Status Detail
Content of Service Status Detail
You do not have the required permissions to view the files attached to this post.
Re: Content of Service Status Detail
This section is not customizable. What details would you like to see?
Your version of XI is quite old and you should consider upgrading soon, below is the Service Status Detail page from a more recent version:
Your version of XI is quite old and you should consider upgrading soon, below is the Service Status Detail page from a more recent version:
You do not have the required permissions to view the files attached to this post.
Be sure to check out the Knowledgebase for helpful articles and solutions!
Re: Content of Service Status Detail
Hi bwallace,
There are statistic data need to be shown under the Service Status Detail, but it only show the header of the messages now.
It is a important item for our daily operation, hope that there will be a new release including this enhancement.
In addition, new version of Nagios XI is under our testing. It seems not quite stable on our environment, we need to take more time to monitor it, thanks!
Larry
There are statistic data need to be shown under the Service Status Detail, but it only show the header of the messages now.
It is a important item for our daily operation, hope that there will be a new release including this enhancement.
In addition, new version of Nagios XI is under our testing. It seems not quite stable on our environment, we need to take more time to monitor it, thanks!
Larry
Re: Content of Service Status Detail
XI version 5.3.0 is right around the corner so take a look at that when it is released (no set release date yet) although I'm unsure if it contains additional features/ data within the Status detail section. But there certainly is a difference in this area between your existing version and 5.2.x.
Feel free to open a new thread for the instability issue you mention. As for this thread, are we good to close it?
Feel free to open a new thread for the instability issue you mention. As for this thread, are we good to close it?
Be sure to check out the Knowledgebase for helpful articles and solutions!