Fusion 4.0.1 on RHEL 7.4.
I have two servers that are fused but do not show up in the TAC status page. I have no auth errors in the logs, and when I click on them in the interface, I can log into them immediately. They just do not show up in the TAC. Any ideas on where to look?
Two servers not checking in
Two servers not checking in
You do not have the required permissions to view the files attached to this post.
--
Griffin Wakem
Griffin Wakem
-
npolovenko
- Support Tech
- Posts: 3457
- Joined: Mon May 15, 2017 5:00 pm
Re: Two servers not checking in
Hello, @gwakem. In Fusion, if you click on Servers menu on the top menu, can you see these two servers in the drop-down list? If you can see them, click on the server name. It will take you to the XI page. Make sure that you're able to see all hosts/services in the XI interface.
If all above works fine I'd probably try to remove and then reconfigure these two servers in Fusion one more time.
If all above works fine I'd probably try to remove and then reconfigure these two servers in Fusion one more time.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
Re: Two servers not checking in
Thank you, that worked. I had redone their settings, but did not remove and reapply from scratch. This can be closed. Have a great weekend!
--
Griffin Wakem
Griffin Wakem
-
kyang
Re: Two servers not checking in
Sounds good! I'll be closing this thread!
If you have any more questions, feel free to create another thread.
Thanks for using the Nagios Support Forum!
If you have any more questions, feel free to create another thread.
Thanks for using the Nagios Support Forum!