Esensors Websensor EM01B Celsius?

ottow · Post by **ottow** » Wed May 30, 2018 4:26 am

Hi,

Is there any way to get the EM01B to do Celsius rather than Fahrenheit?
Would work much better outside the US...

Thanks,

Otto

scottwilkerson · Post by **scottwilkerson** » Wed May 30, 2018 7:42 am

The sensor reports what it is programed to.

If you bought a unit that report is Celsius it will report in Celsius.

This isn't based on Nagios it is based on the sensor, Nagios is just reporting the data the sensor gives.

ottow · Post by **ottow** » Wed May 30, 2018 9:06 am

As your document at https://assets.nagios.com/downloads/nag ... ios-XI.pdf specifically states "Temperature must be specified in Fahrenheit" is seemed reasonable to think there was a way to do this in C too. After all, it is just a conversion...

tcanthonyii · Post by **tcanthonyii** » Wed May 30, 2018 9:26 am

Email the folks at esensors. There are new modules available on their github site that were not available or linked to anyway but from an email from them. They are extremely helpful. I worked with them for months working through some bad chips and bad code before it all got resolved. Regardless the new modules work great.

scottwilkerson · Post by **scottwilkerson** » Wed May 30, 2018 10:50 am

tcanthonyii wrote:Email the folks at esensors. There are new modules available on their github site that were not available or linked to anyway but from an email from them. They are extremely helpful. I worked with them for months working through some bad chips and bad code before it all got resolved. Regardless the new modules work great.

Glad to hear it is resolved!

Nagios Support Forum

Esensors Websensor EM01B Celsius?

Esensors Websensor EM01B Celsius?

Re: Esensors Websensor EM01B Celsius?

Re: Esensors Websensor EM01B Celsius?

Re: Esensors Websensor EM01B Celsius?

Re: Esensors Websensor EM01B Celsius?