Nagios web interface is only showing localhost status

[Roally]

Hi

I'm new to Nagios, I've set it up in a virtual environment with pfSense.
I followed this guide: https://www.linuxincluded.com/monitorin ... sh-part-3/
Everything went right even to the point where the SSH Proxy monitoring wizard showed it was configured correctly.
I treid to reboot Nagios after the configuration which didn't work. The Network Status Map also shows pfSense is up and green.

But after having set upt all monitoring checks all I see under the Service Status in Nagios is my Localhost.
I can't see any check I set up from my pfSense.

Does anyone know to get the checks to work? Thanks

[scottwilkerson]

Can you see the services in Configure -> CCM -> Services ?

Did you apply configuration at the end of the wizard?

[treetop]

Roally, I'm the author of that 3-part series on https://www.linuxincluded.com. Were you able to get this resolved? As Scott mentioned, if you opted to perform the copies via CCM, it sounds like the 'apply configuration' may have been missed. I'd be happy to help any way I can and/or if I need to clarify any portion of the guide!

[scottwilkerson]

Thanks @treetop