This support forum board is for support questions relating to
Nagios XI , our flagship commercial network monitoring solution.
TBT
Posts: 625 Joined: Wed May 18, 2011 1:26 pm
Post
by TBT Fri Dec 14, 2018 8:29 am
tgriep wrote: No, I am out of ideas.
The devices in question have been working correctly for years, find it very odd this was suddenly introduced in an XI upgrade.
Comment on the permission/ownership?
Nagios XI 2024R2.2.1 (8 Servers)
tgriep
Madmin
Posts: 9190 Joined: Thu Oct 30, 2014 9:02 am
Post
by tgriep Fri Dec 14, 2018 10:34 am
The permissions should be good. Running the chown and chmod commands are just dome to make sure the settings are set correctly in case they were set wrong.
Be sure to check out our
Knowledgebase for helpful articles and solutions!
TBT
Posts: 625 Joined: Wed May 18, 2011 1:26 pm
Post
by TBT Mon Dec 17, 2018 9:37 am
Note: I copied one of the offending .cfg files over to another XI Host and let MRTG run as per cron schedule. The same issue was observed.
Nagios XI 2024R2.2.1 (8 Servers)
tgriep
Madmin
Posts: 9190 Joined: Thu Oct 30, 2014 9:02 am
Post
by tgriep Mon Dec 17, 2018 12:23 pm
Are all of the devices using the sane SNMPv3 auth schemes?
Be sure to check out our
Knowledgebase for helpful articles and solutions!
TBT
Posts: 625 Joined: Wed May 18, 2011 1:26 pm
Post
by TBT Mon Dec 17, 2018 12:31 pm
tgriep wrote: Are all of the devices using the sane SNMPv3 auth schemes?
Yes.
Nagios XI 2024R2.2.1 (8 Servers)
tgriep
Madmin
Posts: 9190 Joined: Thu Oct 30, 2014 9:02 am
Post
by tgriep Mon Dec 17, 2018 1:14 pm
Thanks for the update.
Be sure to check out our
Knowledgebase for helpful articles and solutions!
