1.2C > Wizards aren't working

[jwalters]

I've tried to add one of my switches 4-5 times and it detects all ports and when I apply the only thing added is ping, all 48 ports are missing. I was able to add my 24 port switch prior just fine. However, now I'm experiencing a similar issue for all workstations added via wizard. All services but harddisk check is added even though the default settings are selected.

I hadn't tested on 1.2B so I'm not sure if this is a new issue or contiuning... please advise.

[mguthrie]

Have you made any modifications to the wizard templates, or otherwise their parent templates?

The XI wizards get their default settings from the host and service templates, and those wizard templates can also inherit values from some of the "generic" templates. Have you made any changes to those templates recently that might reflect the output that you're getting from the wizards?

Note: Some changes in the templates may not be visible when you run the XI wizards. Try verifying settings in the Core Config Manager for your host or service, the CCM gives the full detail for settings for hosts and services.

[jwalters]

No changes have been made. I recently started from fresh with the update prior to 1.2B and only added my servers via the wizard. Now I'm starting to add more devices and they aren't working. Manual setup is not an option.

Edit: Forgot to mention that I have checked and re-checked in core and the services are missing.

[jwalters]

Is this being looked into? Is there other info I could provide that would help?

[admin]

Hi Jason -

We discovered a bug in 1.2c that caused the switch wizard to fail. We just uploaded a new development snapshot of Nagios XI that should fix the problem. Could you try installing the latest development snapshot and see if that resolves the issue?

http://assets.nagios.com/downloads/nagi ... vel.tar.gz

[jwalters]

I will test early next week. Will this address the issues I've experienced with the Windows Workstation Wizard too? Appears from other posts that additional wizards may be experiencing problems as well. With the Windows Workstation wizard, the hard disk check won't add... It can be added manually though.

[Box293]

I've just downloaded 1.2D and this has fixed the problem.

Glad to see it working again again