Hello XI Support
We've got some series for checks, which are OK to run on 1 of 2 nodes (even if produce "WARN"), but not ok when not running at all ("CRIT")
- how to configure 2 different NRPE checks to behave like the "load balance one"?
Thank you
How to "load balance" a particular check?
Re: How to "load balance" a particular check?
BPI can be used to group two services to get an overall health - https://assets.nagios.com/downloads/nag ... BPI_v2.pdf
Screenshot attached would show OK for the group when both are ok, CRITICAL when both are in warning or critical state, and WARNING if only one is in a warning or critical state.
Screenshot attached would show OK for the group when both are ok, CRITICAL when both are in warning or critical state, and WARNING if only one is in a warning or critical state.
You do not have the required permissions to view the files attached to this post.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
Re: How to "load balance" a particular check?
Thank you, please close the casecdienger wrote:BPI can be used to group two services to get an overall health - https://assets.nagios.com/downloads/nag ... BPI_v2.pdf
Screenshot attached would show OK for the group when both are ok, CRITICAL when both are in warning or critical state, and WARNING if only one is in a warning or critical state.
Re: How to "load balance" a particular check?
Will do. But first I think I'll point out this neat little plugin: check_cluster in case you want an alternative to the bpi route.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.