Install NRPE3.x in VCSA6.0
-
DataAssure
- Posts: 34
- Joined: Thu Jul 31, 2014 8:36 am
Install NRPE3.x in VCSA6.0
I hope to monitor VCSA6.0 resource, but unable to properly installed NRPE3.x, who experienced complete installation and get the data?
Re: Install NRPE3.x in VCSA6.0
Just to be sure, is this an ESXi server that you are trying to monitor?
We have a wizard for VMWare that covers monitoring ESXi.
https://assets.nagios.com/downloads/nag ... ios-XI.pdf
Let me know if this is what you are trying to do, and if this document helps. I'll be glad to assist if you run into any problems.
We have a wizard for VMWare that covers monitoring ESXi.
https://assets.nagios.com/downloads/nag ... ios-XI.pdf
Let me know if this is what you are trying to do, and if this document helps. I'll be glad to assist if you run into any problems.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
Be sure to check out our Knowledgebase for helpful articles and solutions!
Be sure to check out our Knowledgebase for helpful articles and solutions!