XI: 5.7.3 - did the ndo3 "slowness" fix make the release?

[inversecow]

Ahoy folks,

Semi recently I attempted the upgrade from XI 5.6.x to 5.7.2 in my PROD ENV.
Naturally I performed the same upgrade in my TEST ENV and it went off fine.
However, the quantity of checks / scale of my PROD ENV is different than TEST.

To that end, I got bit by the ndo3 bug (reported also by a few others on these forums), where it acts very slowly, and fails to load the "Monitoring Engine Check Statistics" (and possibly other areas).
Via a support ticket, I understood there to be two main options:
1.) Stay at 5.7.x, but downgrade back to ndo2db (not a palatable state for our PROD ENV).
2.) Revert back to 5.6.x, and wait for XI 5.7.3 to be released (which was slated to have the ndo3 fix included).

Thus, I see XI 5.7.3 is released, but observe no mention of the ndo3 "fix" in the changelog (https://www.nagios.com/downloads/nagios-xi/change-log/).
Did the fix make it into this release, or is this still pending?

I would rather ask ahead of time, and save a lot of grief of checking to see mid-upgrade.

Thank you for your time,

[scottwilkerson]

Sorry about that, somehow the changes for NDO3 didn't get added to the page.

They are included and the page has been updated

[inversecow]

Ahoy Scott,

Superb, and thank you!
Looks good, and do close this thread when a moment avails.

[scottwilkerson]

Ahoy Scott,

Superb, and thank you!
Looks good, and do close this thread when a moment avails.

Great!

Locking thread