Question regarding JQuery

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
mbarnes88
Posts: 4
Joined: Mon Dec 02, 2019 4:52 pm

Question regarding JQuery

Post by mbarnes88 »

Is there a way to verify the current running version of JQuery in Nagios XI? I know JQuery was updated to 3.5.1 in the 5.7.1 patch however a recent security scan showed a lower version of JQuery being used and oddly enough the scan happened several weeks after we had upgraded Nagios to 5.7.1. If there is a quick way to verify the current version that would be extremely helpful. Thanks in advance.
dchurch
Posts: 858
Joined: Wed Oct 07, 2020 12:46 pm
Location: Yo mama

Re: Question regarding JQuery

Post by dchurch »

If you hit F12 to open the debugger tools, then go to the network tab, then type in jquery to the search panel, it should show you.
60561-network-trace.png
If you didn't get an 8% raise over the course of the pandemic, you took a pay cut.

Discussion of wages is protected speech under the National Labor Relations Act, and no employer can tell you you can't disclose your pay with your fellow employees.
benjaminsmith
Posts: 5324
Joined: Wed Aug 22, 2018 4:39 pm
Location: saint paul

Re: Question regarding JQuery

Post by benjaminsmith »

HI,

Additionally, there is an older version of jQuery installed but it's only used internally to generate pdf reports. The web interface is using 3.5.1.

--Benjamin
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.

Be sure to check out our Knowledgebase for helpful articles and solutions!
Locked