Error while installing pre-requisites for VMware wizard

[scottwilkerson]

Can you execute the following commands in sequence and then post back the results

Code: Select all

/usr/local/nagios/libexec/check_esx3.pl | head --lines=1 2&>1
echo $?

[MSPk]

i dont see any output on the terminal, the cursor just jumps to the cmmand prompt

[scottwilkerson]

did you run the

Code: Select all

echo $?

after the command?

[MSPk]

Yes, I did add echo $?

[scottwilkerson]

And it didn't return anything?

[MSPk]

Yes, i dont see any information on the command prompt

[scottwilkerson]

If you run

Code: Select all

 echo $? 

in the command prompt it should always give the status of the last command that was run, ie

Code: Select all

0

or

Code: Select all

1

etc...

Are you sure you ran them back to back?

[MSPk]

ok, i did run the command incorrectly earlier.... I have now managed to run it and the out put is 1

[scottwilkerson]

Working another thread on the customer support forum (a colleague maybe) I believe we may have a bug in the current version.

Can you please install the attached wizard through Admin -> Manage Config Wizards and see if it resolves the issue?

Please let us know if this works.

thanks

[MSPk]

Yes, We have installed this wizard and it takes us past the initial screen to configure the VM's , will add a VM and update the post with the details.