check_mrtgtraf: Unable to process MRTG log file

[listening723]

I have status information as check_mrtgtraf: Unable to process MRTG log file for port 1 bandwidth monitoring what should I have to do to resolve this.

[gshergill]

Hi listening723,

I had the same issue.

When I set this up I used followed the advice on post 10 or so of the following link - http://www.howtoforge.com/forums/archiv ... 48484.html

Please refer to the other posts in http://support.nagios.com/forum/viewtop ... f=7&t=8606 where the same question was asked.

Hope this helps. If you require the exact commands I ran I can probably get them, but I essentially followed that guide, changing a few file locations to fit my installation.

Kind Regards,

Gary Shergill

[slansing]

Thank's for the help Gshergill, I was about to shoot over the same link. Hopefully it is the same issue.