issue with host display on dashboard

[sarfarosh]

Hello,
today i have downloaded VMWARE image of nagios Xi & started it with VMPLAYER, everything worked fine until i added host's, but later after adding host's if i go to dashboard it shows 0(zero) host's and services, but the host's are shown in CCM
note: i have used router/switch wizard to add host
httpd log doesn't say much.
have also tried tweaking php.ini by increasing 1.max_execution_time, max_input_time, memory_limit.but it doesn't work.

[abrist]

Have you clicked "apply configuration" after configuring the checks?

[sarfarosh]

i have added host through Router/Switch wizards,and have completed the wizards successfully without any error.
but even after successful completion of wizards, it show 0(zero) Host & switches in dashboard

[sreinhardt]

Can you go to Configure-> CCM -> tools -> Write Configs -> do a verify and write, and put the full output of each back here please.

[sarfarosh]

thanks
have resolved this issue, i was getting error due to corrupt DB

[sreinhardt]

awesome thanks for letting us know!