Hi
I'm trying to set up monitoring for stunnel which runs as a binary as the below shows
root 1037 1 0 Mar06 ? 00:00:40 /usr/bin/stunnel4 /etc/stunnel/user.conf
when trying to monitor this as a process or service it doesn't work - any ideas?
Monitor stunnel or binary?
Re: Monitor stunnel or binary?
Can you show the actual command that you are running from the command line, and the output of it?when trying to monitor this as a process or service it doesn't work - any ideas?
Be sure to check out our Knowledgebase for helpful articles and solutions!
Re: Monitor stunnel or binary?
Testing check from command line...
COMMAND: /usr/local/nagios/libexec/check_nrpe -H address -t 30 -c check_services -a \\'stunnel4\\'
OUTPUT: CHECK_NRPE: Received 0 bytes from daemon. Check the remote server logs for error messages.
COMMAND: /usr/local/nagios/libexec/check_nrpe -H address -t 30 -c check_services -a \\'stunnel4\\'
OUTPUT: CHECK_NRPE: Received 0 bytes from daemon. Check the remote server logs for error messages.
Re: Monitor stunnel or binary?
You may want to run through the possible fixes for this error found in the following document:
http://assets.nagios.com/downloads/nagi ... utions.pdf
http://assets.nagios.com/downloads/nagi ... utions.pdf
Former Nagios employee
"It is turtles. All. The. Way. Down. . . .and maybe an elephant or two."
VI VI VI - The editor of the Beast!
Come to the Dark Side.
"It is turtles. All. The. Way. Down. . . .and maybe an elephant or two."
VI VI VI - The editor of the Beast!
Come to the Dark Side.