> To whom it may concern,
[...]
>
> PING ok - Packet loss = 0%, RTA = 0.80 ms | percent_packet_loss=0%;;;;
> rta=0.80ms;;;;
>
> I have to note that the example 'ping' is about the only plugin which
> does not yet produce any performance data.
>
Performance data round 3 for check_icmp then. What do I do when
packet-loss is 100% ? Since I really don't have any rta in that case,
should I just print out
| rta=ms;warn;crit;; pl=100%;warn;crit;;
or is there some default value for when the measurement isn't available
(0 is a sort of valid value here, although a bit unlikely)?
> Regards, Ben Clewett.
>
--
Andreas Ericsson [email protected]
OP5 AB www.op5.se
Lead Developer
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]